To figure out whether or not your wood floors are finished subsequently a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information middle suggests these tests: First is manage your hand over the wood. If you can quality the texture of the grain, the How To Clean Hardwood Floors With Vinegar And Baking Soda has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, polluted subsequently additives for drying) topped subsequently wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, subsequently polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the How To Clean Hardwood Floors With Vinegar And Baking Soda is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after nearly 10 to 15 minutes, the floors are solid subsequently wax. To surgically remove the white spots, use a fragment of fine steel wool lightly dampened subsequently wax and smooth gently. The last is if you suspect a varnish or shellac, take on a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been solid subsequently one of the older achievement methods, it will flake off.