To figure out whether or not your wood floors are ended behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is control your hand beyond the wood. If you can feel the texture of the grain, the How To Clean Hardwood Floors Without Leaving A Film has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, tainted behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the How To Clean Hardwood Floors Without Leaving A Film is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after nearly 10 to 15 minutes, the floors are unquestionable behind wax. To surgically remove the white spots, use a piece of fine steel wool lightly dampened behind wax and rub gently. The last is if you suspect a varnish or shellac, give a positive response a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been unquestionable behind one of the older realization methods, it will flake off.