To figure out whether or not your wood floors are over and done with when a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is manage your hand higher than the wood. If you can atmosphere the texture of the grain, the How To Clean Hardwood Floors Without Vinegar has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, poisoned when additives for drying) topped when wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, when polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the How To Clean Hardwood Floors Without Vinegar is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after approximately 10 to 15 minutes, the floors are hermetically sealed when wax. To remove the white spots, use a fragment of fine steel wool lightly dampened when wax and massage gently. The last is if you suspect a varnish or shellac, acknowledge a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed when one of the older deed methods, it will flake off.