To figure out whether or not your wood floors are finished taking into account a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is run your hand over the wood. If you can feel the texture of the grain, the How To Clean Hardwood Oak Floors has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, infected taking into account additives for drying) topped taking into account wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, taking into account polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the How To Clean Hardwood Oak Floors is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after not quite 10 to 15 minutes, the floors are hermetic taking into account wax. To cut off the white spots, use a piece of good steel wool lightly dampened taking into account wax and daub gently. The last is if you suspect a varnish or shellac, receive a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetic taking into account one of the older achievement methods, it will flake off.