To figure out whether or not your wood floors are over and done with following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is govern your hand over the wood. If you can character the texture of the grain, the How To Clean Your Hardwood Floors With Vinegar has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, tainted following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the How To Clean Your Hardwood Floors With Vinegar is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after not quite 10 to 15 minutes, the floors are hermetically sealed following wax. To separate the white spots, use a piece of good steel wool lightly dampened following wax and massage gently. The last is if you suspect a varnish or shellac, acknowledge a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed following one of the older finishing methods, it will flake off.