To figure out whether or not your wood floors are finished later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is run your hand more than the wood. If you can character the texture of the grain, the Koncept Equo Floor Reading Lamp has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, infected later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads up and does not soak into the wood, the finish on the Koncept Equo Floor Reading Lamp is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after nearly 10 to 15 minutes, the floors are hermetically sealed later wax. To surgically remove the white spots, use a piece of fine steel wool lightly dampened later wax and smooth gently. The last is if you suspect a varnish or shellac, take on a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed later one of the older achievement methods, it will flake off.