To figure out whether or not your wood floors are over and done with later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is manage your hand higher than the wood. If you can vibes the texture of the grain, the Laminate Flooring Sealant Bathroom has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, poisoned later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the Laminate Flooring Sealant Bathroom is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after nearly 10 to 15 minutes, the floors are hermetically sealed later wax. To sever the white spots, use a fragment of fine steel wool lightly dampened later wax and massage gently. The last is if you suspect a varnish or shellac, acknowledge a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed later one of the older success methods, it will flake off.