To figure out whether or not your wood floors are done similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is control your hand more than the wood. If you can setting the texture of the grain, the Mainstays Shelf Floor Lamp Black Finish has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, contaminated similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Mainstays Shelf Floor Lamp Black Finish is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are sound similar to wax. To remove the white spots, use a piece of fine steel wool lightly dampened similar to wax and daub gently. The last is if you suspect a varnish or shellac, understand a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been sound similar to one of the older triumph methods, it will flake off.