To figure out whether or not your wood floors are ended in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is run your hand on top of the wood. If you can atmosphere the texture of the grain, the Reading Floor Lamp Bhs has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, mixed in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish on the Reading Floor Lamp Bhs is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after just about 10 to 15 minutes, the floors are sound in the same way as wax. To cut off the white spots, use a fragment of good steel wool lightly dampened in the same way as wax and massage gently. The last is if you suspect a varnish or shellac, resign yourself to a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sound in the same way as one of the older expertise methods, it will flake off.