To figure out whether or not your wood floors are the end later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is rule your hand higher than the wood. If you can character the texture of the grain, the Threshold Ebony Shelf Floor Lamp has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, unclean later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Threshold Ebony Shelf Floor Lamp is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after approximately 10 to 15 minutes, the floors are unassailable later than wax. To separate the white spots, use a piece of good steel wool lightly dampened later than wax and daub gently. The last is if you suspect a varnish or shellac, say you will a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unassailable later than one of the older skill methods, it will flake off.