To figure out whether or not your wood floors are over and done with bearing in mind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is manage your hand higher than the wood. If you can atmosphere the texture of the grain, the Tile Floor Cleaning Chemicals has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, infected bearing in mind additives for drying) topped bearing in mind wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, bearing in mind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Tile Floor Cleaning Chemicals is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after practically 10 to 15 minutes, the floors are strong bearing in mind wax. To separate the white spots, use a fragment of fine steel wool lightly dampened bearing in mind wax and daub gently. The last is if you suspect a varnish or shellac, put up with a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been strong bearing in mind one of the older exploit methods, it will flake off.