To figure out whether or not your wood floors are ended subsequent to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is run your hand exceeding the wood. If you can environment the texture of the grain, the Tile Floor Cleaning In Alpharetta Ga has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, impure subsequent to additives for drying) topped subsequent to wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, subsequent to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Tile Floor Cleaning In Alpharetta Ga is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after just about 10 to 15 minutes, the floors are strong subsequent to wax. To sever the white spots, use a fragment of good steel wool lightly dampened subsequent to wax and massage gently. The last is if you suspect a varnish or shellac, undertake a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been strong subsequent to one of the older ability methods, it will flake off.