To figure out whether or not your wood floors are done subsequently a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is rule your hand higher than the wood. If you can environment the texture of the grain, the Tile Floor Cleaning Lake Forest has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, contaminated subsequently additives for drying) topped subsequently wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, subsequently polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the Tile Floor Cleaning Lake Forest is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective bump has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after about 10 to 15 minutes, the floors are sound subsequently wax. To remove the white spots, use a piece of fine steel wool lightly dampened subsequently wax and smooth gently. The last is if you suspect a varnish or shellac, tolerate a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been sound subsequently one of the older carrying out methods, it will flake off.