To figure out whether or not your wood floors are finished afterward a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance middle suggests these tests: First is direct your hand exceeding the wood. If you can mood the texture of the grain, the Tile Floor Cleaning Machines Domestic has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, unclean afterward additives for drying) topped afterward wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, afterward polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the Tile Floor Cleaning Machines Domestic is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after just about 10 to 15 minutes, the floors are hermetic afterward wax. To remove the white spots, use a piece of fine steel wool lightly dampened afterward wax and massage gently. The last is if you suspect a varnish or shellac, say you will a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetic afterward one of the older talent methods, it will flake off.