To figure out whether or not your wood floors are finished like a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance center suggests these tests: First is direct your hand beyond the wood. If you can vibes the texture of the grain, the Tile Floor Cleaning Mop has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, mixed like additives for drying) topped like wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, like polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the Tile Floor Cleaning Mop is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after just about 10 to 15 minutes, the floors are solid like wax. To sever the white spots, use a piece of fine steel wool lightly dampened like wax and rub gently. The last is if you suspect a varnish or shellac, take on a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been solid like one of the older triumph methods, it will flake off.