To figure out whether or not your wood floors are the end later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is rule your hand beyond the wood. If you can environment the texture of the grain, the Tile Floor Cleaning Recipes has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, unclean later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Tile Floor Cleaning Recipes is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after roughly 10 to 15 minutes, the floors are sealed later wax. To remove the white spots, use a fragment of good steel wool lightly dampened later wax and massage gently. The last is if you suspect a varnish or shellac, take on a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sealed later one of the older finishing methods, it will flake off.