To figure out whether or not your wood floors are over and done with subsequent to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is govern your hand higher than the wood. If you can feel the texture of the grain, the Tile Floor Cleaning San Antonio has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, dirty subsequent to additives for drying) topped subsequent to wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, subsequent to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish on the Tile Floor Cleaning San Antonio is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after not quite 10 to 15 minutes, the floors are sealed subsequent to wax. To sever the white spots, use a piece of good steel wool lightly dampened subsequent to wax and smear gently. The last is if you suspect a varnish or shellac, resign yourself to a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sealed subsequent to one of the older realization methods, it will flake off.