To figure out whether or not your wood floors are done behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is direct your hand exceeding the wood. If you can feel the texture of the grain, the Tile Floor Cleaning Vero Beach has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, impure behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Tile Floor Cleaning Vero Beach is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after virtually 10 to 15 minutes, the floors are unassailable behind wax. To cut off the white spots, use a fragment of fine steel wool lightly dampened behind wax and smooth gently. The last is if you suspect a varnish or shellac, assume a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been unassailable behind one of the older ability methods, it will flake off.