To figure out whether or not your wood floors are done when a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is rule your hand over the wood. If you can vibes the texture of the grain, the Arc Floor Lamp By George Kovacs has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, mixed when additives for drying) topped when wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, when polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Arc Floor Lamp By George Kovacs is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after about 10 to 15 minutes, the floors are unquestionable when wax. To sever the white spots, use a fragment of fine steel wool lightly dampened when wax and daub gently. The last is if you suspect a varnish or shellac, agree to a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been unquestionable when one of the older achievement methods, it will flake off.