To figure out whether or not your wood floors are ended subsequently a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is direct your hand higher than the wood. If you can vibes the texture of the grain, the Best Concrete Garage Floor Stain has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, polluted subsequently additives for drying) topped subsequently wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, subsequently polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the Best Concrete Garage Floor Stain is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after just about 10 to 15 minutes, the floors are hermetically sealed subsequently wax. To sever the white spots, use a piece of fine steel wool lightly dampened subsequently wax and massage gently. The last is if you suspect a varnish or shellac, take a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed subsequently one of the older ability methods, it will flake off.