To figure out whether or not your wood floors are finished considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance middle suggests these tests: First is direct your hand beyond the wood. If you can feel the texture of the grain, the Eternity Flooring Barnwood has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, contaminated considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads up and does not soak into the wood, the finish on the Eternity Flooring Barnwood is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are unassailable considering wax. To sever the white spots, use a piece of fine steel wool lightly dampened considering wax and smear gently. The last is if you suspect a varnish or shellac, take a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been unassailable considering one of the older feat methods, it will flake off.