To figure out whether or not your wood floors are over and done with in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is govern your hand higher than the wood. If you can setting the texture of the grain, the Eternity Flooring Bedford Collection has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, infected in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Eternity Flooring Bedford Collection is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after nearly 10 to 15 minutes, the floors are hermetic in imitation of wax. To remove the white spots, use a piece of fine steel wool lightly dampened in imitation of wax and massage gently. The last is if you suspect a varnish or shellac, assume a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetic in imitation of one of the older completion methods, it will flake off.