To figure out whether or not your wood floors are the end in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is rule your hand higher than the wood. If you can feel the texture of the grain, the Eternity Flooring Brilliance Collection has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, unclean in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the Eternity Flooring Brilliance Collection is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are sealed in the manner of wax. To sever the white spots, use a fragment of good steel wool lightly dampened in the manner of wax and rub gently. The last is if you suspect a varnish or shellac, agree to a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sealed in the manner of one of the older talent methods, it will flake off.