To figure out whether or not your wood floors are the end with a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is run your hand higher than the wood. If you can vibes the texture of the grain, the Eternity Flooring Cabana Collection has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, dirty with additives for drying) topped with wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, with polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Eternity Flooring Cabana Collection is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after not quite 10 to 15 minutes, the floors are sealed with wax. To cut off the white spots, use a piece of good steel wool lightly dampened with wax and daub gently. The last is if you suspect a varnish or shellac, say yes a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sealed with one of the older carrying out methods, it will flake off.