To figure out whether or not your wood floors are over and done with following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is direct your hand more than the wood. If you can quality the texture of the grain, the Eternity Flooring China has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, contaminated following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Eternity Flooring China is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after more or less 10 to 15 minutes, the floors are hermetic following wax. To sever the white spots, use a piece of good steel wool lightly dampened following wax and massage gently. The last is if you suspect a varnish or shellac, take a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetic following one of the older realization methods, it will flake off.