To figure out whether or not your wood floors are ended following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is direct your hand on top of the wood. If you can atmosphere the texture of the grain, the Eternity Flooring Forever Collection has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, impure following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads up and does not soak into the wood, the finish upon the Eternity Flooring Forever Collection is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after nearly 10 to 15 minutes, the floors are sound following wax. To cut off the white spots, use a piece of good steel wool lightly dampened following wax and rub gently. The last is if you suspect a varnish or shellac, understand a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been sound following one of the older endowment methods, it will flake off.