To figure out whether or not your wood floors are the end bearing in mind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is rule your hand higher than the wood. If you can atmosphere the texture of the grain, the Eternity Flooring Hayward has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, contaminated bearing in mind additives for drying) topped bearing in mind wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, bearing in mind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Eternity Flooring Hayward is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are unassailable bearing in mind wax. To sever the white spots, use a fragment of fine steel wool lightly dampened bearing in mind wax and smooth gently. The last is if you suspect a varnish or shellac, admit a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unassailable bearing in mind one of the older attainment methods, it will flake off.