To figure out whether or not your wood floors are done similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is direct your hand beyond the wood. If you can tone the texture of the grain, the Eternity Flooring Los Angeles has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, infected similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Eternity Flooring Los Angeles is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are solid similar to wax. To cut off the white spots, use a piece of good steel wool lightly dampened similar to wax and rub gently. The last is if you suspect a varnish or shellac, take a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been solid similar to one of the older deed methods, it will flake off.