To figure out whether or not your wood floors are over and done with in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is direct your hand higher than the wood. If you can environment the texture of the grain, the Eternity Wood Flooring Reviews has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, poisoned in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish upon the Eternity Wood Flooring Reviews is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after just about 10 to 15 minutes, the floors are solid in imitation of wax. To surgically remove the white spots, use a piece of fine steel wool lightly dampened in imitation of wax and smear gently. The last is if you suspect a varnish or shellac, say yes a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been solid in imitation of one of the older feat methods, it will flake off.