To figure out whether or not your wood floors are finished once a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is control your hand over the wood. If you can atmosphere the texture of the grain, the Flooring Company About Us has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, unclean once additives for drying) topped once wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, once polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Flooring Company About Us is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after roughly 10 to 15 minutes, the floors are solid once wax. To remove the white spots, use a piece of good steel wool lightly dampened once wax and massage gently. The last is if you suspect a varnish or shellac, say you will a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been solid once one of the older achievement methods, it will flake off.