To figure out whether or not your wood floors are the end subsequent to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is manage your hand higher than the wood. If you can feel the texture of the grain, the Flooring Company Belfast has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, contaminated subsequent to additives for drying) topped subsequent to wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, subsequent to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Flooring Company Belfast is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after practically 10 to 15 minutes, the floors are sealed subsequent to wax. To separate the white spots, use a fragment of fine steel wool lightly dampened subsequent to wax and smooth gently. The last is if you suspect a varnish or shellac, understand a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been sealed subsequent to one of the older feat methods, it will flake off.