To figure out whether or not your wood floors are the end past a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is govern your hand on top of the wood. If you can atmosphere the texture of the grain, the Flooring Company Bristol has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, infected past additives for drying) topped past wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, past polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish on the Flooring Company Bristol is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are hermetically sealed past wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened past wax and rub gently. The last is if you suspect a varnish or shellac, understand a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed past one of the older success methods, it will flake off.