To figure out whether or not your wood floors are ended next a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is run your hand higher than the wood. If you can air the texture of the grain, the Flooring Company Epsom has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, contaminated next additives for drying) topped next wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, next polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Flooring Company Epsom is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after about 10 to 15 minutes, the floors are unquestionable next wax. To separate the white spots, use a fragment of fine steel wool lightly dampened next wax and smooth gently. The last is if you suspect a varnish or shellac, consent a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unquestionable next one of the older completion methods, it will flake off.