To figure out whether or not your wood floors are finished later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is govern your hand on top of the wood. If you can air the texture of the grain, the Flooring Company Essex has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, contaminated later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Flooring Company Essex is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after approximately 10 to 15 minutes, the floors are hermetically sealed later wax. To separate the white spots, use a piece of fine steel wool lightly dampened later wax and rub gently. The last is if you suspect a varnish or shellac, bow to a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed later one of the older endowment methods, it will flake off.