To figure out whether or not your wood floors are finished next a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is direct your hand over the wood. If you can atmosphere the texture of the grain, the Flooring Company In Qatar has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, impure next additives for drying) topped next wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, next polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Flooring Company In Qatar is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after approximately 10 to 15 minutes, the floors are hermetically sealed next wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened next wax and rub gently. The last is if you suspect a varnish or shellac, give a positive response a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed next one of the older realization methods, it will flake off.