To figure out whether or not your wood floors are finished later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is manage your hand higher than the wood. If you can tone the texture of the grain, the Flooring Company Katy has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, impure later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the Flooring Company Katy is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after approximately 10 to 15 minutes, the floors are unquestionable later wax. To remove the white spots, use a piece of good steel wool lightly dampened later wax and smooth gently. The last is if you suspect a varnish or shellac, put up with a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unquestionable later one of the older realization methods, it will flake off.