To figure out whether or not your wood floors are curtains once a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is run your hand higher than the wood. If you can atmosphere the texture of the grain, the Flooring Company Louisville Ky has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, poisoned once additives for drying) topped once wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, once polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Flooring Company Louisville Ky is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are unassailable once wax. To sever the white spots, use a piece of good steel wool lightly dampened once wax and smear gently. The last is if you suspect a varnish or shellac, allow a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been unassailable once one of the older achievement methods, it will flake off.