To figure out whether or not your wood floors are ended gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion middle suggests these tests: First is run your hand greater than the wood. If you can setting the texture of the grain, the Flooring Company Miami has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, impure gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Flooring Company Miami is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after very nearly 10 to 15 minutes, the floors are hermetically sealed gone wax. To separate the white spots, use a fragment of fine steel wool lightly dampened gone wax and smooth gently. The last is if you suspect a varnish or shellac, endure a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed gone one of the older triumph methods, it will flake off.