To figure out whether or not your wood floors are over and done with considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is rule your hand greater than the wood. If you can feel the texture of the grain, the Flooring Company Portslade has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, polluted considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the Flooring Company Portslade is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are hermetic considering wax. To sever the white spots, use a fragment of good steel wool lightly dampened considering wax and smooth gently. The last is if you suspect a varnish or shellac, take on a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been hermetic considering one of the older carrying out methods, it will flake off.