To figure out whether or not your wood floors are done in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is control your hand on top of the wood. If you can quality the texture of the grain, the Flooring Company Poughkeepsie New York has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, dirty in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the Flooring Company Poughkeepsie New York is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are sealed in the same way as wax. To separate the white spots, use a fragment of fine steel wool lightly dampened in the same way as wax and smooth gently. The last is if you suspect a varnish or shellac, give a positive response a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sealed in the same way as one of the older talent methods, it will flake off.