To figure out whether or not your wood floors are done bearing in mind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is control your hand exceeding the wood. If you can environment the texture of the grain, the Flooring Company Redditch has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, dirty bearing in mind additives for drying) topped bearing in mind wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, bearing in mind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Flooring Company Redditch is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after nearly 10 to 15 minutes, the floors are solid bearing in mind wax. To cut off the white spots, use a piece of good steel wool lightly dampened bearing in mind wax and daub gently. The last is if you suspect a varnish or shellac, admit a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been solid bearing in mind one of the older attainment methods, it will flake off.