To figure out whether or not your wood floors are done later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is run your hand exceeding the wood. If you can mood the texture of the grain, the Flooring Company Toronto has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, unclean later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Flooring Company Toronto is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after approximately 10 to 15 minutes, the floors are unquestionable later than wax. To remove the white spots, use a fragment of good steel wool lightly dampened later than wax and massage gently. The last is if you suspect a varnish or shellac, consent a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unquestionable later than one of the older endowment methods, it will flake off.