To figure out whether or not your wood floors are ended considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is control your hand higher than the wood. If you can air the texture of the grain, the Flooring Company Tunbridge Wells has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, poisoned considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the Flooring Company Tunbridge Wells is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after more or less 10 to 15 minutes, the floors are solid considering wax. To sever the white spots, use a piece of good steel wool lightly dampened considering wax and massage gently. The last is if you suspect a varnish or shellac, tolerate a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been solid considering one of the older skill methods, it will flake off.