To figure out whether or not your wood floors are curtains later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is rule your hand higher than the wood. If you can air the texture of the grain, the Flooring Company Wandsworth Bridge Road has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, infected later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the Flooring Company Wandsworth Bridge Road is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after nearly 10 to 15 minutes, the floors are sealed later than wax. To cut off the white spots, use a piece of good steel wool lightly dampened later than wax and rub gently. The last is if you suspect a varnish or shellac, put up with a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sealed later than one of the older triumph methods, it will flake off.