To figure out whether or not your wood floors are the end later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is manage your hand more than the wood. If you can feel the texture of the grain, the Flooring Company Windsor has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, mixed later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Flooring Company Windsor is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after just about 10 to 15 minutes, the floors are strong later than wax. To remove the white spots, use a piece of fine steel wool lightly dampened later than wax and daub gently. The last is if you suspect a varnish or shellac, allow a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been strong later than one of the older talent methods, it will flake off.