To figure out whether or not your wood floors are the end similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is govern your hand over the wood. If you can tone the texture of the grain, the Flooring Contractors Austin Tx has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, impure similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the Flooring Contractors Austin Tx is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after roughly 10 to 15 minutes, the floors are sound similar to wax. To separate the white spots, use a piece of good steel wool lightly dampened similar to wax and rub gently. The last is if you suspect a varnish or shellac, say yes a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been sound similar to one of the older expertise methods, it will flake off.