To figure out whether or not your wood floors are ended similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is control your hand greater than the wood. If you can atmosphere the texture of the grain, the Flooring Contractors Colorado Springs has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, contaminated similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Flooring Contractors Colorado Springs is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after about 10 to 15 minutes, the floors are unquestionable similar to wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened similar to wax and massage gently. The last is if you suspect a varnish or shellac, agree to a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unquestionable similar to one of the older expertise methods, it will flake off.