To figure out whether or not your wood floors are curtains next a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is run your hand higher than the wood. If you can tone the texture of the grain, the Flooring Contractors Fredericksburg Va has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, contaminated next additives for drying) topped next wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, next polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Flooring Contractors Fredericksburg Va is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after about 10 to 15 minutes, the floors are sealed next wax. To sever the white spots, use a fragment of good steel wool lightly dampened next wax and smear gently. The last is if you suspect a varnish or shellac, recognize a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sealed next one of the older endowment methods, it will flake off.