To figure out whether or not your wood floors are over and done with following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is rule your hand on top of the wood. If you can vibes the texture of the grain, the Flooring Contractors Gainesville Fl has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, tainted following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Flooring Contractors Gainesville Fl is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after nearly 10 to 15 minutes, the floors are unassailable following wax. To sever the white spots, use a fragment of fine steel wool lightly dampened following wax and smear gently. The last is if you suspect a varnish or shellac, say you will a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been unassailable following one of the older endowment methods, it will flake off.