To figure out whether or not your wood floors are done later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is direct your hand over the wood. If you can feel the texture of the grain, the Flooring Contractors Houston has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, dirty later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Flooring Contractors Houston is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective bump has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are unquestionable later than wax. To sever the white spots, use a piece of fine steel wool lightly dampened later than wax and rub gently. The last is if you suspect a varnish or shellac, acknowledge a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unquestionable later than one of the older success methods, it will flake off.